Suzuki GSX-R 1000 Service Manual: Rear brake light switch inspection and adjustment
Check the rear brake light switch so that the brake light will come on just before pressure is felt when the brake pedal is depressed. If the brake light switch adjustment is necessary, turn the adjuster nut (1) in or out while holding the brake pedal.
Brake fluid level check
Refer to “brake system inspection” in section 0b .
Brake hose inspection
Refer to “brake system inspection” in section 0b .
Rear brake light switch inspection
Inspect the rear brake light switch in the following
procedures:
lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Discon ...
Air bleeding from brake fluid circuit
Air trapped in the brake fluid circuit acts like a cushion to
absorb a large proportion of the pressure developed by
the master cylinder and thus interferes with the full
braking performance of the ...
Other materials:
Stopping and parking
Twist the throttle grip away
from yourself to close the
throttle completely.
Apply the front and rear brakes
evenly and at the same time.
Downshift through the gears
as road speed decreases.
Select neutral with the clutch
lever squeezed toward the grip
(disenga ...
Cooling system inspection
Inspect cooling system
every 6 000 km (4 000 miles, 6 months)
Replace engine coolant
every 2 years
Engine coolant level inspection
Hold the motorcycle vertically.
Check the engine coolant level by observing the “f” and “l” lines on
the engine coolant reservoir tank. If the level i ...
Rear brake master cylinder parts inspection
Refer to “rear brake master cylinder disassembly and assembly” .
Master cylinder
Inspect the master cylinder bore for any scratches or
other damage.
Piston / rubber parts
Inspect the piston surface for any scratches or other
damage.
Inspect the primary cup, secondary cup and dust boot
...