Refer to “rear brake hose routing diagram” (page 4a- 2).
Removal
Installation
Install the rear brake master cylinder in the reverse order of removal. Pay attention to the following points:
Caution the seal washers should be replaced with the new ones to prevent fluid leakage. |
: Thread lock cement
99000–32110
(thread lock cement super “1322” or
equivalent)
Tightening torque rear brake master cylinder mounting bolt (a): 10 n·m (1.0 Kgf-m, 7.0 Lbf-ft) brake hose union bolt (b): 23 n·m (2.3 Kgf-m, 16.5 Lbf-ft)
Cam chain guide / cam chain tensioner
removal and installation
Removal
Remove the cylinder head cover. Refer to “engine top side disassembly” .
Remove the cam chain guide no. 2 (1).
Remove the cylinder head. Refer to “engine top side disassembly”
and “engine bottom side disassembly” .
Remove the starter clutch. Refer to “s ...
DTC “c42” (p1650): ig switch circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
Ignition switch signal is not input to the ecm.
Ignition system circuit open or short.
Ecm malfunction.
When the id agreement is not verified.
Ecm does not re ...
Drive chain replacement
Use the special tool in the following procedures, to cut
and rejoin the drive chain.
Note
when using the special tool, apply a small
quantity of grease to the threaded parts of
the special tool.
Special tool
: 09922–22711 (drive chain cutting
and joint
tool set)
Driv ...