Suzuki GSX-R 1000 Service Manual: Rear brake master cylinder components

Front brake master cylinder parts inspection

Refer to “front brake master cylinder / brake lever disassembly and assembly” . Master cylinder Inspect the master cylinder bore for any scratches or other damage Piston / rubber parts Insp ...

Rear brake master cylinder assembly removal and installation

Refer to “rear brake hose routing diagram” (page 4a- 2). Removal Remove the right side frame cover. Refer to “exterior parts removal and installation” in section 9d .  Remove the rear ...

Other materials:

Diagnostic information and procedures
Starting system symptom diagnosis Condition Possible cause Correction / reference item Engine does not turn though the starter motor runs Faulty starter clutch. Replace. Starter button is not effective Run down battery Repair or replac ...

Front brake pad inspection
The extent of brake pads wear can be checked by observing the grooved limit line “a” on the pads. When the wear exceeds the grooved limit line, replace the pads with new ones. Refer to “front brake pad replacement” . Caution replace the brake pad as a set, otherwise braking perform ...

Heated oxygen sensor (ho2s) removal and installation
Removal Do not remove the ho2 sensor while it is hot.   Caution  be careful not to expose the ho2 sensor to excessive shock.  Do not use an impact wrench when removing or installing the ho2 sensor.  Be careful not to twist or damage t ...