Suzuki GSX-R 1000 Service Manual: Rear brake master cylinder disassembly and assembly

Suzuki GSX-R 1000 Service Manual / Brake / Brake control system and diagnosis / Repair instructions / Rear brake master cylinder disassembly and assembly

Refer to “rear brake master cylinder assembly removal and installation” .

Disassembly

Disconnect the reservoir hose (1).
Remove the lock-nut (2).

Suzuki GSX-R. Rear brake master cylinder disassembly and assembly

Remove the brake hose connector (3) and o-ring (4).

Special tool : 09900–06108 (snap ring remover
(close type))

Suzuki GSX-R. Rear brake master cylinder disassembly and assembly

Pull out the dust boot (5) and remove the snap ring (6).

Special tool : 09900–06108 (snap ring remover
(close type))

Suzuki GSX-R. Rear brake master cylinder disassembly and assembly

Remove the push rod (7), piston/cup set (8) and spring (9).

Suzuki GSX-R. Rear brake master cylinder disassembly and assembly

Assembly

Assemble the master cylinder in the reverse order of disassembly. Pay attention to the following points:

Caution

wash the master cylinder components with new brake fluid before reassembly.
Do not wipe the brake fluid off after washing the components.
When washing the components, use the specified brake fluid. Never use different types of fluid or cleaning solvents such as gasoline, kerosine, etc.
Apply brake fluid to the master cylinder bore and all of the master cylinder component to be inserted into the bore.

Bf: brake fluid (dot 4)

Suzuki GSX-R. Rear brake master cylinder disassembly and assembly

Apply grease to the push rod end.

: Grease 99000–25100 (suzuki
silicone grease or equivalent)

Suzuki GSX-R. Rear brake master cylinder disassembly and assembly

Caution

replace the o-ring with a new one.

Suzuki GSX-R. Rear brake master cylinder disassembly and assembly

Rear brake master cylinder assembly removal and installation

Refer to “rear brake hose routing diagram” (page 4a- 2). Removal Remove the right side frame cover. Refer to “exterior parts removal and installation” in section 9d . Remove the rear ...

Rear brake master cylinder parts inspection

Refer to “rear brake master cylinder disassembly and assembly” . Master cylinder Inspect the master cylinder bore for any scratches or other damage. Piston / rubber parts Inspect the piston s ...

Other materials:

Rear turn signal light removal and installation
Removal Remove the frame cover assembly. Refer to “exterior parts removal and installation” in section 9d . Remove the rear combination light. Refer to “rear combination light removal and installation” . Disconnect the lead wire coupler (1). (Lh: white, rh: black) &nb ...

Lower light bulb
Turn the socket 1 counterclockwise and remove it. Turn the socket 2 counterclockwise and remove it. Remove the bulb 3 from the socket. Caution Oil from your skin may damage the headlight bulb or shorten its life. Grasp the new bulb with a c ...

Voltage check
If voltage is supplied to the circuit being checked, voltage check can be used as circuit check. With all connectors/couplers connected and voltage applied to the circuit being checked, measure voltage between each terminal and body ground. If measurements were taken as shown ...