Caution do not operate the brake pedal while the pads are removed. |
Caution replace the brake pads as a set, otherwise braking performance will be adversely affected. |
Note make sure that the detent of the pads is seated onto the retainers on the caliper bracket. |
Tightening torque rear brake pad mounting pin (a): 17 n·m (1.7 Kgf-m, 12.5 Lbf-ft) rear brake pad mounting pin plug (b): 2.5 N·m ( 0.25 Kgf-m, 2.0 Lbf-ft)
Note after replacing the brake pads, pump the brake pedal several times to check for proper brake operation and then check the brake fluid level. |
Water pump construction
Impeller
Mechanical seal
Oil seal
O-ring
O-ring
8
N·m (0.8 Kgf-m, 6.0 Lbf-ft)
10 N·m
(1.0 Kgf-m, 7.0 Lbf-ft)
Apply grease.
Apply engine coolant.
Apply molybdenum oil
solution.
Do not reuse.
...
Starting off
Warning
Riding this motorcycle at
excessive speed increases
your chances of losing control
of the motorcycle. This may
result in an accident.
Always ride within the limits of
your skills, your motorcycle,
and the riding conditions.
Warning
Remov ...
Speed sensor inspection
Inspect the speed sensor in the following procedures:
remove the speed sensor. Refer to “speed sensor removal and
installation” .
Connect a 12 v battery (between b and b/w), 10 kù
resistor (between b/r and b) and multi-circuit tester
(tester (+) probe to b and tester ...