Suzuki GSX-R 1000 Owners Manual: Rear brake pedal adjustment
The rear brake pedal position must be properly adjusted at all times or the disk brake pads will bear against the disk causing damage to the pads and to the disk surface. Adjust the brake pedal posit~ on in the following manner:
- Loosen lock nut 1, and turn the push rod 2 to locate the pedal 55 - 65 mm (2.2 - 2.6 In) below the top face of the footrest.
- Retighten lock nut 1 to secure push rod 2 in the proper position.
|
Caution An incorrectly adjusted brake pedal may force brake pads to rub against the disk at all times, causing damage to the pads and disk. Follow the steps in this section to adjust the brake pedal properly. |
Brake pad
Front
Rear
Inspect the front and rear brake
pads to see if they are worn down
to the grooved wear limit line 1. If
a pad is worn to the grooved wear
limit line, it must be replaced with
...
Rear brake light switch
To adjust the brake light switch,
hold the switch body and turn the
adjuster so that the brake light will
come on just before a pressure
rise is felt when the brake pedal is
depressed. ...
Other materials:
Throttle valve synchronization
Check and adjust the throttle valve synchronization
among four cylinders.
Start the engine and run it in idling condition
for
warming up.
Stop the warmed-up engine.
Lift and support the fuel tank. Refer to “fuel
tank
removal and installation” in section 1g (page ...
Fuel discharge amount inspection
Keep away from fire or spark.
Spilled gasoline should be wiped off
immediately.
Work in a well-ventilated area.
Inspect the fuel discharge amount in the following
procedures:
lift and support the fuel tank. Refer to “fuel tank remo ...
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Front wheel components” “front wheel assembly construction” “rear
wheel components” “rear wheel assembly construction”
Special tool
...