Suzuki GSX-R 1000 Service Manual: Rear brake pedal removal and installation
Removal
- Remove the master cylinder assembly. Refer to “rear brake master cylinder assembly removal and installation” .
- Disconnect the rear brake light switch lead wire coupler. Refer to “rear brake light switch inspection” .
- Remove the rear brake pedal as shown in the rear brake pedal construction. Refer to “rear brake pedal construction” .
Installation
| Caution replace the snap ring with a new one. |
Install the rear brake pedal as shown in the rear brake pedal construction. Refer to “rear brake pedal construction” .
Rear brake pedal construction
Footrest bracket no. 2
Footrest bracket no. 1
Rear brake peda
Footrest holder
Footrest
35 N·m (3.5 Kgf-m,
25.5 Lbf-ft)
23 N·m
(2.3 Kgf-m, 16. ...
Specifications
Service data
Brake
unit: mm (in)
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Front brake hose routing diagram” ...
Other materials:
Starter motor components
O-ring
Housing end (inside)
O-ring
Starter motor case
Armature
Housing end (outside)
10
N·m (1.0 Kgf-m, 7.0 Lbf-ft)
4 N·m (0.4
Kgf-m, 3.0 Lbf-ft)
5 N·m (0.5
Kgf-m, 3.5 Lbf-ft)
Apply grease to sliding
surface
Apply moly ...
Accessory use
The addition of unsuitable accessories
can lead to unsafe operating
conditions. It is not possible
for suzuki to test each accessory
on the market or combinations of
all the available accessories; however,
your dealer can assist you in
selecting quality accessories and
installing them correc ...
Throttle body inspection and cleaning
Refer to “throttle body disassembly and assembly” .
Cleaning
Some
carburetor cleaning chemicals,
especially dip-type soaking solutions, are
very corrosive and must be handled carefully.
Always follow the chemical manufacturer’s
instructions on proper use, handling and
sto ...