Cooling fan relay inspection
Inspect the fan relay in the following procedures:
remove the frame covers. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Remove the cooling fan relay (1).
First check the insulation between “a” and “b”
terminals with tester. Then ap ...
Charging system symptom diagnosis
Condition
Possible cause
Correction / reference item
Generator does not
charge
Open- or short-circuited lead wires, or
loose lead connections.
Repair, replace or connect properly.
Short-circuited, grounded or open
generator coil.
Replace
...
Clutch adjustment
Clutch cable play should be 1 0 -
15 mm (0.4 - 0.6 In) measured at
the clutch lever end. Adjust clutch
cable play according to the following
procedure:
Minor adjustment
Turn the clutch cable adjuster 1
to provide the specified play.
Major adjustment
Turn in the adjuster 1 all the ...