Removal
Installation
Install the rear combination light in the reverse order of removal. Pay attention to the following point:
Note when reusing the removed bolts (1), apply a small quantity of the thread lock to them. |
Tightening torque rear combination light mounting bolt (a): 2.8 N·m (0.28 Kgf-m, 2.0 Lbf-ft)
: Thread lock cement
99000–32110
(thread lock cement super “1322” or
equivalent)
Rear combination light replacement
Caution if led operation is abnormal, replace the rear combination light with a new one. |
Starter motor runs but does not crank the
engine
The starter motor runs when the transmission is in neutral, but does not run
when the transmission is in any position
other than neutral, with the side-stand up.
Step
Action
Yes
No
1
Check the side-stand switch. Refer to “side-stand / ignition
inte ...
Engine coolant
Coolant level
The engine coolant solution
should be between "f" (full) and
"1..:' (Low) level lines on the engine
coolant reservoir. If the level is
lower than "1..:' (Low) level line,
bring it up to "f" (full) level by adding
50:50 mixture of distilled water ...
Evaporative emission control system
inspection (only for e-33)
Refer to “evaporative emission control system removal and installation (only
for e-33)” .
Hose
Inspect the hoses for wear or damage. If it is worn or
damage, replace the hose with a new one.
Note
make sure that the hoses are securely
connected.
Evap canister
Inspect the eva ...