The seat lock is located under the left frame cover. To remove the rear seat, insert the ignition key into the lock and turn it clockwise.
Raise the front end of the seat and slide it forward.
To reinstall the seat, slide the seat hooks into the seat hook retainers and push down firmly until the seat snaps into the locked position.
Warning
Latch the seat securely in its proper position. |
A seat tail cover for solo riding can be attached by using the same procedure as the rear seat.
Ap sensor removal and installation
Removal
Remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Disconnect the starter relay (1) from the holder.
Disconnect the coupler (2) and remove the ap
sensor (3).
Installation
Install the ap sensor in the rever ...
Steering system inspection
Inspect steering system
initially at 1 000 km (600 miles, 2 months) and every
12 000 km (7 500 miles, 24 months) thereafter
Steering should be adjusted properly for smooth turning
of handlebars and safe running. Overtighten steering
prevents smooth turning of the handlebars and too loose
steer ...
Gearshift shaft / gearshift cam plate removal
and installation
Removal
Remove the engine sprocket cover. Refer to “engine sprocket removal and
installation” in section 3a .
Remove the clutch components. Refer to “clutch removal” in section 5c .
Remove the snap ring (1) and washer (2) from the
gearshift shaft.
Special tool
: 09900–06 ...