Suzuki GSX-R 1000 Service Manual: Rear shock absorber bearing removal and installation
Removal
- Remove the rear shock absorber. Refer to “rear shock absorber removal and installation” .
- Remove the spacer (1).
- Remove the rear shock absorber bearing with the special tool.
Special tool
(a): 09943–88211 (pinion bearing
installer)
Installation
| Caution the removed bearing must be replaced with a new one. |
- Press the bearing into the rear shock absorber at 0.5 Mm (0.02 In) depth “a” from the rear shock absorber side surface with the special tool and suitable size socket wrench.
| Note apply a small quantity of the grease to housing when installing the bearing. |
: Grease 99000–25010 (suzuki
super
grease “a” or equivalent)
Special tool
(a): 09924–84521 (bearing installer
set)
|
- Apply grease to the bearing.
: Grease 99000–25010 (suzuki super grease “a” or equivalent)
- Install the rear shock absorber. Refer to “rear shock absorber removal and installation” .
Rear shock absorber inspection
Refer to “rear shock absorber removal and installation” .
Shock absorber
Inspect the rear shock absorber for damage and oil
leakage, and absorber bushing for wear and damage. If
any defect is foun ...
Rear shock absorber adjustment
After installing the rear suspension, adjust the spring
pre-load and damping force as follows:
Spring pre-load adjustment
The set length 179.3 Mm (7.06 In) provides the
maximum spring pre-load ...
Other materials:
Precautions
Precautions for driveline / axle
Refer to “general precautions” in section 00 (page 00-1).
Never inspect or
adjust the drive chain while the engine is running.
Caution
do not use trichloroethylene, gasoline or such similar
solvent. These fluids will d ...
Cylinder head cover related parts
inspection
Refer to “engine top side disassembly” .
Refer to “engine top side assembly” .
Refer to “cylinder head cover disassembly and assembly” .
Cylinder head cover
Clean and check the gasket grooves “a” and pair reed
valve mating surfaces “b” of the cylinder head cover.
If there is anything unu ...
Crankcase breather (pcv) hose / reed
valve / cover removal and installation
Removal
Lift and support the fuel tank with the prop stay.
Refer to “fuel tank removal and installation” in section 1g .
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect the crankcase breather (pcv) hose (1).
...