Refer to “rear shock absorber removal and installation” .
The rear shock absorber unit contains high-pressure nitrogen gas.
|
Gas pressure release
Make sure to observe the following precautions:
|
|
|
Starter motor will not run
Note
make sure the fuses are not blown and the battery is fully-charged
before diagnosing.
Troubleshooting
Step
Action
Yes
No
1
Shift the transmission into neutral.
Grasp the clutch lever, turn on the ignition switch ...
Water pump disassembly and assembly
Refer to “water pump removal and installation” .
Disassembly
Remove the air bleeder bolt (1) if necessary.
Remove the water pump case screws.
Remove the o-ring (2).
Hold the impeller (3) with water pump pliers and
remove the impeller securing bolt (4).
Remove t ...
DTC “c41” (p2505): ecm power input signal
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C41/P2505
No voltage is applied to the ecm.
Lead wire/coupler connection of ecm terminal to fuel
fuse.
Fuel fuse.
Wiring diagram
Troubleshooting
C ...