Suzuki GSX-R 1000 Service Manual: Rear shock absorber inspection
Refer to “rear shock absorber removal and installation” .
Shock absorber
Inspect the rear shock absorber for damage and oil leakage, and absorber bushing for wear and damage. If any defect is found, replace the rear shock absorber with a new one.
| Caution do not attempt to disassemble the rear shock absorber. It is unserviceable. |
Spacer
- Remove the spacer from the cushion lever.
- Inspect the spacer for any flaws or other damage. If any defect is found, replace the spacer with a new one.
Rear shock absorber bearing
- Insert the spacer into bearing.
- Check the play by moving the spacer up and down. If excessive play is noted, replace the bearing with a new one. Refer to “rear shock absorber removal and installation” .
Rear shock absorber removal and installation
Removal
Remove the right side cowling and side frame covers. Refer to “exterior
parts removal and installation” in section 9d .
Support the motorcycle with a jack to relieve load on
t ...
Rear shock absorber bearing removal and installation
Removal
Remove the rear shock absorber. Refer to “rear shock absorber removal
and installation” .
Remove the spacer (1).
Remove the rear shock absorber bearing with the
spec ...
Other materials:
Rear turn signal light removal and installation
Removal
Remove the frame cover assembly. Refer to “exterior parts removal and
installation” in section 9d .
Remove the rear combination light. Refer to “rear combination light
removal and installation” .
Disconnect the lead wire coupler (1).
(Lh: white, rh: black)
&nb ...
Tire pressure and loading
Proper tire pressure and proper
tire loading are important factors.
Overloading your tires can lead to
tire failure and loss of vehicle control.
Check tire pressure each day
before you ride, and be sure the
pressure is correct for the vehicle
load according to the table below.
Tire pre ...
Pair control solenoid valve removal and
installation
Removal
Lift and support the fuel tank with the prop stay.
Refer to “fuel tank removal and installation” in section 1g .
Remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Remove the pair control solenoid valve (1) along
with the pair ...