Toyota RAV4 manuals

Suzuki GSX-R 1000 Service Manual: Rear turn signal light bulb replacement

Caution

when you touch the bulb with your bare hands, clean the bulb with a cloth moistened with alcohol or soap water to prevent premature bulb failure.

  1. Remove the rear turn signal light lens (1).

Suzuki GSX-R. Rear turn signal light bulb replacement


  1. Replace the bulb (2).

Suzuki GSX-R. Rear turn signal light bulb replacement


  1. Reinstall the removed parts
Rear turn signal light removal and installation
Removal Remove the frame cover assembly. Refer to “exterior parts removal and installation” in section 9d .  Remove the rear combination light. Refer to “rear combination light remova ...

Reflex reflector construction
Front reflex reflector x 2 pcs. (For e-03, 24, 28, 33) Rear reflex reflector x 2 pcs. (For e-03, 28, 33) 1.8 N·m (0.18 Kgf-m, 1.5 Lbf-ft) ...

Other materials:

Rear wheel assembly removal and installation
Removal Loosen the axle nut (1).  Raise the rear wheel off the ground and support the motorcycle with a jack or wooden block. Caution make sure that the motorcycle is supported securely. Remove the axle nut (1).  Loosen the left and right lock-nuts (2) an ...

Rear wheel removal
Place the motorcycle on the side stand. Remove the cotter pin 1.  Remove the axle nut 2. Warning A hot muffler can burn you. The muffler will be hot enough to burn you for some time after stopping the engine. Wait until the muffler cools to avoid bur ...

Drive chain adjustment
Inspect the drive chain slack before each use of the motorcycle. Place the motorcycle on the side stand. The drive chain should be adjusted for 20 - 30 mm (0.8 - 1.2 In) of slack, as shown. Warning Too much chain slack can cause the chain to come off the sprockets, resul ...

© 2011-2026 Copyright www.suzukigsxr.org