Toyota RAV4 manuals

Suzuki GSX-R 1000 Service Manual: Rear wheel assembly construction

Suzuki GSX-R. Rear wheel assembly construction


  1. Rear sprocket nut
  2. Rear axle nut
  3. Brake disc bolt
  4. Clearance
  5. 60 N·m (6.0 Kgf-m,
    43.0 Lbf-ft)
  6. 100 N·m
    (10 kgf-m, 72.5 Lbf-ft)
  7. 35 N·m
    (3.5 Kgf-m, 25.5 Lbf-ft)

Apply grease.


Apply thread lock to the
thread part.

Rear wheel components
Rear axel nut Collar Dust seal Bearing Retainer Rear sprocket Sprocket mounting drum Wheel damper Bearing Spacer Air valve Rear wheel ...

Rear wheel assembly removal and installation
Removal Loosen the axle nut (1).  Raise the rear wheel off the ground and support the motorcycle with a jack or wooden block. Caution make sure that the motorcycle is support ...

Other materials:

Fuel injection system description
Gsx-r1000 motorcycles are equipped with a fuel injection system for emission level control. This fuel injection system is precision designed, manufactured and adjusted to comply with the applicable emission limits. With varying engine conditions, all of the fuel injection volumes are precisely ...

Starter clutch inspection
Refer to “starter clutch removal and installation” . Starter clutch Install the starter driven gear onto the starter clutch.  Turn the starter driven gear by hand to inspect the starter clutch for a smooth movement. The gear turns in one direction only. If a large resistance is felt ...

Starter motor runs but does not crank the engine
The starter motor runs when the transmission is in neutral, but does not run when the transmission is in any position other than neutral, with the side-stand up. Step Action Yes No 1 Check the side-stand switch. Refer to “side-stand / ignition inte ...

© 2011-2024 Copyright www.suzukigsxr.org