Suzuki GSX-R 1000 Service Manual: Rear wheel components
|
100 N·m (10.0 Kgf-m,
35 N·m
60 N·m
Apply grease
Apply thread lock to the
Do not reuse.
Front wheel dust seal / bearing removal and installation
Removal
Remove the front wheel assembly. Refer to “front wheel assembly removal
and installation” .
Remove the dust seals using the special tool.
Special tool
(a): 09913–50121 (oil ...
Rear wheel assembly construction
Rear sprocket nut
Rear axle nut
Brake disc bolt
Clearance
60 N·m (6.0 Kgf-m,
43.0 Lbf-ft)
100 N·m
(10 kgf-m, 72.5 Lbf-ft)
35 N·m
(3.5 Kg ...
Other materials:
Self-diagnostic procedures
Use of mode select switch
Note
do not disconnect the coupler from ecm,
battery cable from battery, ecm ground
wire from engine or main fuse before
confirming dtc (diagnostic trouble code)
stored in memory. Such disconnection
may erase memorized information in ec ...
Specifications
Service data
Injector + fuel pump + fuel pressure regulator
Fuel
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Fuel pump components”
Reference: for the tightening torque of fastener not specified in this
se ...
Transmission installation
Install the transmission in the reverse order of removal.
Pay attention to the following points:
Bearing and oil seal
Caution
replace the removed bearings and oil seals
with new ones.
Install the driveshaft left bearing oil seal into the
retainer using the special tool.
...