Removal
Special tool
(a): 09913–50121 (oil seal
remover)
Special tool
(b): 09921–20240 (bearing remover
set)
Installation
Caution the removed dust seal and bearings must be replaced with new ones. |
: Grease 99000–25010 (suzuki
super
grease “a” or equivalent)
Special tool
(a): 09941–34513 (bearing
installer)
(b): 09924–84510 (bearing
installer set)
Caution the sealed cover of the bearing must face outside. |
|
Special tool
(c): 09913–70210 (bearing
installing set (10
– 75 Ô))
: Grease 99000–25010 (suzuki
super
grease “a” or equivalent)
Dimmer / passing light switch inspection
Inspect the dimmer/passing light switch in the following
procedures:
remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect the left handlebar switch coupler (1).
(Yellow)
Inspect the dimmer/passing light switch ...
Clutch parts inspection
Refer to “clutch removal” and “clutch installation” .
Clutch drive and driven plate
Note
wipe off the engine oil from the drive and
driven plates with a clean rag.
Measure the thickness of drive plates with a vernier
calipers. If the drive plate thickness is found to have ...
DTC “c41” (p0230-h/l): fp relay circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
C41
No voltage is applied to fuel pump.
Fuel pump relay circuit open or short.
Fuel pump relay malfunction.
Fuel pump relay switch circuit is shorted to power
source.
...