Refer to “rear wheel assembly removal and installation” .
Tire
Refer to “tire inspection” in section 0b .
Rear brake disc
Refer to “rear brake disc inspection” in section 4c .
Wheel damper
Refer to “drive chain related parts inspection” in section 3a .
Sprocket
Refer to “drive chain related components” in section 3a .
Dust seal
Inspect the dust seal lip for wear or damage. If any defects is found, replace the dust seal with a new one.
Refer to “rear wheel dust seal / bearing removal and installation” .
Wheel axle
Using a dial gauge, check the wheel axle for runout, if the runout exceeds the limit, replace the axle shaft.
Wheel axle runout service limit: 0.25 Mm (0.010 In)
Special tool
(a): 09900–20607 (dial gauge)
(b): 09900–20701 (dial gauge
chuck)
(c): 09900–21304 (v blocks)
Wheel
Wheel rim runout service limit (axial and radial): 2.0 Mm (0.08 In)
Bearing
Inspect the play of the wheel bearings by hand while they are in the wheel. Rotate the inner race by hand to inspect for abnormal noise and smooth rotation. Replace the bearing if there is anything unusual. Refer to “rear wheel dust seal / bearing removal and installation” .
Damping force adjustment
The rebound and compression
damping force can be individually
adjusted by turning the respective
adjusters. The rebound damping
force adjuster 1 is located at the
bottom of the rear suspension.
The compression damping force
adjuster 2 is located at the left
side of the motorcycle.
To ad ...
Specifications
Service data
Brake
unit: mm (in)
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Front brake hose routing diagram” “rear brake hose routing
diagram” “front brake master cylinder components” “rear
...
Light bulb replacement
The wattage rating of each bulb is
shown in the following chart.
When replacing a burned-out
bulb, always use the same wattage
rating according to the following
chart.
Caution
Using a light bulb with the
wrong wattage rating can
cause electrical system damage
or shorte ...