Toyota RAV4 manuals

Suzuki GSX-R 1000 Service Manual: Regulator / rectifier construction

Suzuki GSX-R. Regulator / rectifier construction


  1. Regulator/rectifier
  2. Regulator/rectifier bracket
  3. Air intake pipe (rh)
  4. Spacer
  5. Wiring harness
  6. Connect
    the regulator/rectifier couplers under the wiring harness
  7. 10
    N·m (1.0 Kgf-m, 7.0 Lbf-ft)
Generator removal and installation
Removal Drain engine oil. Refer to “engine oil and filter replacement” in section 0b .  Remove the left side cowling. Refer to “exterior parts removal and installation” in section 9d ...

Regulator / rectifier removal and installation
Removal Turn the ignition switch off.  Remove the right side cowling. Refer to “exterior parts removal and installation” in section 9d .  Lift and support the fuel tank. Refer to ...

Other materials:

Specifications
Service data Brake unit: mm (in) Tightening torque specifications Note the specified tightening torque is described in the following. “Rear brake components” Reference: for the tightening torque of fastener not specified in this section, refer to “tightening torqu ...

Isc valve reset
When removing or replacing the throttle body assembly, reset the isc valve learned value in the following procedures:  turn the ignition switch on position. Set up the sds tools. (Refer to the sds operation manual for further details.)  Click “active control”.  Click “is ...

Schematic and routing diagram
Cooling circuit diagram Water hose routing diagram Thermostat air bleeder hole Cushion O-ring Radiator heat guard : be careful not to damage the pawls when removing. Yellow marking White marking Clamp end should face downward ...

© 2011-2024 Copyright www.suzukigsxr.org