Engine oil and filter replacement
Refer to “engine oil and filter replacement” in section 0b .
Engine oil level inspection
Refer to “engine oil and filter replacement” in section 0b .
Starting the engine
Before attempting to start the
engine, make sure:
The transmission is in neutral.
The engine stop switch is in
the "" position.
Note: this motorcycle has a
starter interlock system for the
ignition and starter circuit. The
engine can only be started if:
  ...
Clutch lifter pin inspection and adjustment
Refer to “clutch removal” and “clutch installation” .
Note
when inspection and adjusting the clutch
lifter pin, it is not necessary to install the
clutch onto the countershaft.
Inspect and adjust the clutch lifter pin in the following
procedures:
assemble the ...
Oil jet inspection
Refer to “oil jet removal and installation” .
Oil jet
Make sure that the oil jets are not clogged. If they are
clogged, clean their oil passage using a wire of the
proper size and compressed air.
Piston cooling jet
Oil jet (for transmission)
Oil jet (for cam chain te ...