Drive mode selector inspection
Inspect the drive mode selector in the following procedures:
set up the sds tool. (Refer to the sds operation manual for
further details.)
Turn the ignition switch on.
Click “data monitor”.
Make sure each of “driving mode selection” on the monitor is
indicated ...
Battery charging
Initial charging
filling electrolyte
Note
when filling electrolyte, the battery must be
removed from the vehicle and must be put on
the level ground.
Remove the aluminum tape (1) which seals the
battery filler holes “a”.
Remove the caps (2) from the electrolyte ...
Radiator reservoir tank inspection
Inspect the radiator reservoir tank in the following
procedures:
remove the right side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Inspect the radiator reservoir tank (1) for leaks. If any
defects are found, replace the radiator reservoir tank
...