Suzuki GSX-R 1000 Owners Manual: Riding tips
- Starting the engine
- Starting off
- Using the transmission
- Riding on hills
- Stopping and parking
- Carrying a passenger
Inspection before riding
Warning
Failure to inspect and maintain
your motorcycle properly
increases the chance of an
accident or equipment damage.
Always perform a pre-ride
inspection before each ride ...
Starting the engine
Before attempting to start the
engine, make sure:
The transmission is in neutral.
The engine stop switch is in
the "" position.
Note: this motorcycle has a
starter i ...
Other materials:
Drive chain replacement
Use the special tool in the following procedures, to cut
and rejoin the drive chain.
Note
when using the special tool, apply a small
quantity of grease to the threaded parts of
the special tool.
Special tool
: 09922–22711 (drive chain cutting
and joint
tool set)
Driv ...
Turn signal / side-stand relay removal and
installation
Removal
Turn the ignition switch off.
Remove the frame cover assembly. Refer to “exterior parts removal and
installation” in section 9d .
Remove the turn signal/side-stand relay (1).
Installation
Install the turn signal/side-stand relay in the reverse
order of removal ...
Clutch cable removal and installation
Removal
Remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the clutch cable from the clutch lever.
Refer to “handlebar removal and installation” in section 6b .
Remove the clutch cable as shown in the throttle cable ro ...