Engine stop switch 1
"" Position
The ignition circuit is off. The engine cannot start or run.
"" Position
The ignition circuit is on and the engine can run.
Front brake lever 2
Apply the front brake by squeezing the front brake lever towards the grip. The brake light will come on when the lever is squeezed.
Front brake lever adjustment
The distance between the throttle grip and the front brake lever is adjustable among six positions. To change the position, push the brake lever forward and turn the adjuster to the desired position.
When changing the brake lever position, always be sure the adjuster stops in the proper position; a projection of the brake lever holder should fit into the depression of the adjuster. This motorcycle is delivered from the factory with its adjuster set on position 3.
Warning
Always keep both hands on the handlebars while riding. |
Electric starter button "" 3
Use this button to operate the
starter motor. With the ignition
switch in the "on" position, the
engine stop switch in the ""
position, and the transmission is
in neutral, pull in the clutch lever
and push the electric starter button
to start the engine.
Note
: this motorcycle has a starter interlock system for the ignition and starter circuit. The engine can only be started if:
Caution To prevent electrical system damage, do not operate the starter motor longer than five seconds at a time. If the engine does not start after several attempts, check the fuel supply and ignition system. Refer to the troubleshooting section in this manual. |
Throttle grip 4
Engine speed is controlled by the position of the throttle grip. Twist it toward you to increase engine speed. Turn it away from you to decrease the engine speed.
Rear suspension assembly construction
Rear shock absorber mounting bolt (upper)
Rear shock absorber mounting nut (lower)
Cushion rod mounting nut (front)
Cushion rod mounting nut (rear)
Cushion lever mounting nut
Swingarm pivot nut
Swingarm pivot boss nut
Swingarm pivot shaft
Swingarm ...
Symbols
Listed in the table below are the symbols indicating instructions and other
information necessary for servicing.
The meaning of each symbol is also included in the table.
Abbreviations
A:
abdc: after bottom dead center
ac: alternating current
acl: air cleaner, air cleaner box
api: ame ...
Spark plug inspection and cleaning
Inspect spark plug
every 6 000 km (4 000 miles, 12 months)
Heat range
Remove the spark plugs. Refer to “ignition coil and spark plug removal
and installation” in section 1h .
Check spark plug heat range by observing electrode
color. If the electrode of the spark plug is wet
appe ...