Using sds, sample the data at the time of new and periodic vehicle inspections.
After saving the sampled data in the computer, file them by model and by user.
The periodically filed data help improve the accuracy of troubleshooting since they can indicate the condition of vehicle functions that has changed with time.
For example, when a vehicle is brought in for service but the troubleshooting of a failure is not easy, comparing the current data value to past filed data value at time of normal condition can allow the specific engine failure to be determined.
Also, in the case of a customer vehicle which is not periodically brought in for service with no past data value having been saved, if the data value of a good vehicle condition have been already saved as a master (std), comparison between the same models helps to facilitate the troubleshooting.
Special tool
: 09904–41010 (suzuki diagnostic
system set)
: 99565–01010–020 (cd-rom ver.20)
Note
|
Sample
Data sampled from cold starting through warm-up
Data at 3 000 r/min under no load
Data at the time of racing
Data of intake negative pressure during idling (100 °c)
Data of manifold absolute pressure operation at the time of starting
Example of trouble
Three data; value 3 (current data 3), value 1 (past data 1) and value 2 (past data 2); can be made in comparison by showing them in the graph. Read the change of value by comparing the current data to the past data that have been saved under the same condition, then you may determine how changes have occurred with the passing of time and identify what problem is currently occurring.
Note with dtc not output, if the engine idling speed and isc valve stepping position are found to be abnormal than the data saved previously, the possible cause may probably lie in the hardware side such as isc valve air inlet hose crumple, bend, etc. |
Radiator cap inspection
Inspect the radiator cap in the following procedures:
remove the radiator cap. Refer to “cooling circuit inspection” .
Attach the radiator cap (1) to the radiator tester (2)
as shown.
Slowly apply pressure to the radiator cap.
If the radiator cap does not hold the pre ...
Helmet holders
This motorcycle has helmet holders
underneath the rear seat.
Hook your helmet on the helmet holder and lock the seat.
Warning
Riding with a helmet fastened
to the helmet holder can interfere
with rider control.
Never carry a helmet fastened
to the helmet holder. Fix the
...
Rear brake pedal removal and installation
Removal
Remove the master cylinder assembly. Refer to “rear brake master
cylinder assembly removal and installation” .
Disconnect the rear brake light switch lead wire coupler. Refer to
“rear brake light switch inspection” .
Remove the rear brake pedal as shown in the rear ...