Valve + guide unit: mm (in
Camshaft + cylinder head unit: mm (in
Cylinder + piston + piston ring unit: mm (in)
Conrod + crankshaft unit: mm (in)
Balancer unit: mm (in)
Throttle body
Cushion rod bearing removal and installation
Removal
Remove the cushion rod. Refer to “cushion rod removal and installation”
.
Remove the cushion rod bearing with the special
tool.
Special tool
(a):
09921–20240 (bearing remover set)
Installation
Caution
the removed bearings must be replaced with
new on ...
Speed sensor inspection
Inspect the speed sensor in the following procedures:
remove the speed sensor. Refer to “speed sensor removal and
installation” .
Connect a 12 v battery (between b and b/w), 10 kù
resistor (between b/r and b) and multi-circuit tester
(tester (+) probe to b and tester ...
Cam chain tension adjuster inspection
The cam chain tension adjuster is maintained to proper
tension automatically.
Remove the cam chain tension adjuster. Refer to “engine top side
disassembly” .
Holding the cam chain tension adjuster as shown in
the figure, compress the plunger by turning the
adjuster body unt ...