Suzuki GSX-R 1000 Service Manual: Short circuit check (wire harness to ground)
- Disconnect the negative (–) cable from the battery.
- Disconnect the connectors/couplers at both ends of the circuit to be checked.
| Note if the circuit to be checked branches to other parts as shown, disconnect all connectors/ couplers of those parts. Otherwise, diagnosis will be wrong. |
- Measure resistance between terminal at one end of circuit (“a” terminal in figure) and body ground. If continuity is indicated, there is a short circuit to ground between terminals “a” and “c”.
|
- Disconnect the connector/coupler included in circuit (coupler “b”) and measure resistance between terminal “a” and body ground. If continuity is indicated, the circuit is shorted to ground between terminals “a” and “b”.
|
Voltage check
If voltage is supplied to the circuit being checked, voltage
check can be used as circuit check.
With all connectors/couplers connected and voltage
applied to the circuit being checked, m ...
Using the multi-circuit testers
Use the suzuki multi-circuit tester set.
Use well-charged batteries in the tester.
Be sure to set the tester to the correct testing range.
Special tool
(A): 09900–25008
(multi ...
Other materials:
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Fuel pump components”
Special tool
...
Drive chain adjustment
Inspect the drive chain slack
before each use of the motorcycle.
Place the motorcycle on the
side stand. The drive chain
should be adjusted for 20 - 30
mm (0.8 - 1.2 In) of slack, as
shown.
Warning
Too much chain slack can
cause the chain to come off the
sprockets, resul ...
Combination meter inspection
Led inspection
Check that the leds “a” (fi, fuel, engine rpm, oil
pressure/engine coolant, immobilizer (e-02, 19, 24, 51)
and meter panel illumination) immediately light up when
the ignition switch is turned on.
Check that the other leds “b” (neutral, high-beam and
turn signal indicator ligh ...