Use of sds
Ecm stores the engine and driving conditions (in the form of data as shown in the figure) at the moment of the detection of a malfunction in its memory. This data is called “show data when trouble”.
Therefore, it is possible to know engine and driving conditions (e.G., Whether the engine was warm or not, where the motorcycle was running or stopped) when a malfunction was detected by checking the show data when trouble. This show data when trouble function can record the maximum of two diagnostic trouble codes in the ecm.
Also, ecm has a function to store each show data when trouble for two different malfunctions in the order of occurrence as the malfunction is detected. Utilizing this function, it is possible to know the order of malfunctions that have been detected. Its use is helpful when rechecking or diagnosing a trouble.
Rear brake master cylinder assembly removal and installation
Refer to “rear brake hose routing diagram” (page 4a-
2).
Removal
Remove the right side frame cover. Refer to “exterior parts removal and
installation” in section 9d .
Remove the rear brake fluid reservoir mounting bolt
(1).
Drain brake fluid. Refer to “brake fluid replac ...
Starter relay removal and installation
Removal
Turn the ignition switch off.
Remove the front seat. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Disconnect the battery (–) lead wire (1) from the
battery.
Remove the starter relay cover (2) and disconnect
the starter rel ...
Accessory use
The addition of unsuitable accessories
can lead to unsafe operating
conditions. It is not possible
for suzuki to test each accessory
on the market or combinations of
all the available accessories; however,
your dealer can assist you in
selecting quality accessories and
installing them correc ...