An interlock switch is provided to cut off the ignition circuit when the side stand is down and the transmission is in any gear other than neutral.
The side stand/ignition interlock switch works as follows:
Warning
|
Caution Park the motorcycle on firm, level ground to help prevent it from falling over. If you must park on an incline, aim the front of the motorcycle uphill and put the transmission into 1st gear to reduce the possibility of rolling off the side stand. |
Rear brake master cylinder components
Reservoir cap
Plate
Diaphragm
Reservoir tank
Reservoir hose
Brake hose
Brake hose union bolt
Brake hose connector
Master cylinder
Spring
Piston/cup set
Push rod
Dust boot
23 N·m (2.3 Kgf-m,
16.5 Lbf-ft)
10 N·m
...
Air cleaner box removal and installation
Removal
Lift and support the fuel tank. Refer to “fuel tank
removal and installation” in section 1g (page 1g-
9).
Remove the air cleaner box cover. Refer to “air cleaner element removal
and installation” .
Remove the air cleaner mounting bolt.
Remove the air clea ...
Tp sensor adjustment
Inspect the tp sensor setting position and adjust it if
necessary in the following procedures:
connect the special tool (mode select switch) to the dealer mode
coupler. Refer to “self-diagnostic procedures” in section 1a .
Special tool
: 09930–82720 (mode selection switch)
Warn ...