Recommended service material

| Note required service material is also described in the following. “Front fork components” |
Special tool

Specifications
Rear suspensionIgnition switch inspection
Inspect the ignition switch in the following procedures:
remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect the ignition switch lead wire coupler (1).
Inspect the ignition switch for continuity with a tester.
If ...
Combination meter inspection
Led inspection
Check that the leds “a” (fi, fuel, engine rpm, oil
pressure/engine coolant, immobilizer (e-02, 19, 24, 51)
and meter panel illumination) immediately light up when
the ignition switch is turned on.
Check that the other leds “b” (neutral, high-beam and
turn signal indicator ligh ...
Cooling fan relay inspection
Inspect the fan relay in the following procedures:
remove the frame covers. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Remove the cooling fan relay (1).
First check the insulation between “a” and “b”
terminals with tester. Then ap ...