Tightening torque specifications
Note the specified tightening torque is described in the following. “Chassis bolt and nut inspection” |
Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Heated oxygen sensor (ho2s) removal and
installation
Removal
Do not
remove the ho2 sensor while it is hot.
Caution
be careful not to expose the ho2 sensor to
excessive shock.
Do not use an impact wrench when
removing or installing the ho2 sensor.
Be careful not to twist or damage t ...
Radiator reservoir tank removal and
installation
Removal
Remove the right side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the reservoir tank inlet hose (1) from the
reservoir tank (2) and drain the engine coolant.
Remove the reservoir tank (2).
Disconnect the reservoir tank ove ...
Rear brake caliper parts inspection
Refer to “rear brake caliper disassembly and assembly” .
Brake caliper cylinder
Inspect the brake caliper cylinder wall for nicks,
scratches or other damage. If any damage is found,
replace the caliper with a new one.
Brake caliper piston
Inspect the brake caliper piston surface for any
s ...