Service data
Oil pump
Oil
Tightening torque specifications
Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Voltage check
If voltage is supplied to the circuit being checked, voltage
check can be used as circuit check.
With all connectors/couplers connected and voltage
applied to the circuit being checked, measure
voltage between each terminal and body ground.
If measurements were taken as shown ...
Clutch installation
Install the primary driven gear assembly (1).
Caution
if it is difficult to install the primary driven
gear, rotate the crankshaft.
Be sure to engage the oil pump drive
sprocket with the primary driven gear.
Install the spacer (2) and bea ...
Rear brake pedal removal and installation
Removal
Remove the master cylinder assembly. Refer to “rear brake master
cylinder assembly removal and installation” .
Disconnect the rear brake light switch lead wire coupler. Refer to
“rear brake light switch inspection” .
Remove the rear brake pedal as shown in the rear ...