Service data
Wheel unit: mm (in)
Tire
Tightening torque specifications
Note the specified tightening torque is described in the following. “Front wheel components” “front wheel assembly construction” “rear wheel components” “rear wheel assembly construction” |
Reference
: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .
Damping force adjustment
The rebound and compression
damping force can be individually
adjusted by turning the respective
adjusters. The rebound damping
force adjuster 1 is located at the
bottom of the rear suspension.
The compression damping force
adjuster 2 is located at the left
side of the motorcycle.
To ad ...
Using the transmission
The transmission is provided to
keep the engine operating
smoothly in its normal operating
speed range. The gear ratios
have been carefully chosen to
meet the characteristics of the
engine. The rider should always
select the most suitable gear for
the prevailing conditions. Never
slip the c ...
Throttle valve synchronization
Check and adjust the throttle valve synchronization
among four cylinders.
Start the engine and run it in idling condition
for
warming up.
Stop the warmed-up engine.
Lift and support the fuel tank. Refer to “fuel
tank
removal and installation” in section 1g (page ...