Toyota RAV4 manuals

Suzuki GSX-R 1000 Service Manual: Specifications

Tightening torque specifications

Note

the specified tightening torque is described in the following.

“Body frame construction”  “front footrest bracket construction”  “side-stand construction”

Reference

: for the tightening torque of fastener not specified in this section, refer to “tightening torque list” in section 0c .

Special tools and equipment

Recommended service material

Note

required service material is also described in the following.

“Front footrest bracket construction”  “side-stand construction”  “pillion footrest construction”

Side-stand removal and installation
Removal Support the motorcycle with a jack or wooden block. Caution  do not support the motorcycle with the exhaust pipes.  Make sure that the motorcycle is supported s ...

Other materials:

Fuel level gauge inspection
Inspect the fuel level gauge in the following procedures:  remove the fuel pump. Refer to “fuel pump disassembly and assembly” in section 1g .  Measure the resistance at each fuel level gauge in float position. If the resistance is incorrect, replace fuel level gauge with a ne ...

Crankshaft thrust clearance inspection and selection
Refer to “engine bottom side disassembly” (page 1d- 49). Refer to “engine bottom side assembly” . Inspection With the crankshaft’s right-side and left-side thrust bearings inserted into the upper crankcase.  Measure the thrust clearance “a” between the leftside thrust bearing and ...

Stopping and parking
Twist the throttle grip away from yourself to close the throttle completely.  Apply the front and rear brakes evenly and at the same time.  Downshift through the gears as road speed decreases.  Select neutral with the clutch lever squeezed toward the grip (disenga ...

© 2011-2026 Copyright www.suzukigsxr.org