Suzuki GSX-R 1000 Service Manual: Speed sensor inspection
Inspect the speed sensor in the following procedures:
- remove the speed sensor. Refer to “speed sensor removal and installation” .
- Connect a 12 v battery (between b and b/w), 10 kù resistor (between b/r and b) and multi-circuit tester (tester (+) probe to b and tester (–) probe to b/r) as shown in the figure.
Special tool
: 09900–25008 (multi circuit tester
set)
Tester knob indication
voltage (
)
|
- Move a screwdriver back and forth across the pickup surface of the speed sensor. The voltage readings should cycle as follows (0 v → 12 v or 12 v → 0 v). If the voltage reading does not change, replace the speed sensor with a new one.
| Note while testing, the highest voltage reading should be the same as the battery voltage (12 v). |
Speed sensor removal and installation
Removal
Remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the speed sensor lead wire coupler (1).
Remove the speed se ...
Oil pressure indicator inspection
Inspect the oil pressure indicator in the following
procedures:
Note
before inspecting the oil pressure switch, check if the engine oil level
is correct. Refer to “engine oil and filte ...
Other materials:
Special tools and equipment
Recommended service material
Note
required service material is also described in the following.
“Drive chain related components”
Special tool
...
Steering / steering damper removal and
installation
Removal
steering damper
Turn the ignition switch off.
Disconnect the steering damper solenoid coupler
(1).
Remove the lower bracket cover (2).
Remove the steering damper mounting nut (3) while
holding the lock-nut (4).
Remove the steering damper mounting bolt ( ...
Rear shock absorber inspection
Refer to “rear shock absorber removal and installation” .
Shock absorber
Inspect the rear shock absorber for damage and oil
leakage, and absorber bushing for wear and damage. If
any defect is found, replace the rear shock absorber with
a new one.
Caution
do not attempt to disassemble ...