Removal
Installation
Install the speed sensor in the reverse order of removal.
Pay attention to the following points:
Tightening torque speed sensor mounting bolt (a): 6.5 N·m (0.65 Kgf-m, 4.5 Lbf-ft)
Air cleaner
The air cleaner element must be
kept clean to provide good engine
power and g1as mileage. If you use
your motorcycle under normal
low-stress conditions, you should
service the air cleaner at the intervals
specified. If you ride in dusty,
wet, or muddy conditions, you will
need to inspect the ...
Front turn signal light removal and installation
Removal
Remove the screw.
Disconnect the front turn signal coupler (1).
Remove the turn signal light assembly (2).
Installation
Install the front turn signal light in the reverse order of
removal. ...
Clutch lifter pin inspection and adjustment
Refer to “clutch removal” and “clutch installation” .
Note
when inspection and adjusting the clutch
lifter pin, it is not necessary to install the
clutch onto the countershaft.
Inspect and adjust the clutch lifter pin in the following
procedures:
assemble the ...