Refer to “starter clutch removal and installation” .
Starter clutch
If they are found to be damaged, replace them with new ones.
Starter clutch bearing and starter driven gear
Inspect the starter clutch bearing and starter clutch contacting surface on the starter driven gear for wear and damage. If they are found to be damaged, replace them with new ones.
Turn signal / side-stand relay inspection
Refer to “electrical components location” in section 0a .
Note
make sure that the battery is fully charged.
Before removing the turn signal/side-stand relay, check
the operation of the turn signal light.
If the turn signal light does not illuminate, inspect the
bulb, turn signa ...
Balancer shaft journal bearing removal and
installation
Refer to “engine bottom side disassembly” (page 1d-
49).
Refer to “engine bottom side assembly” .
Removal
Remove the balancer shaft journal bearings (1).
Note
do not remove the bearings (1) unless
absolutely necessary.
Make a note of where the bearings are
r ...
Cooling fan inspection
Cooling fan operating temperature
standard
(on → off): approx. 100 ?‹C (212 ƒ‹f)
(off → on): approx. 105 ?‹C (221 ƒ‹f)
Inspect the cooling fan in the following procedures:
disconnect the cooling fan motor coupler (1).
Test the cooling fan motor for load ...