Refer to “starter motor removal and installation” .
Disassembly
Disassemble the starter motor as shown in the starter motor components diagram. Refer to “starter motor components” .
Assembly
Reassemble the starter motor in the reverse order of removal. Pay attention to the following points:
Caution replace the o-rings with new ones to prevent oil leakage and moisture. |
Apply grease to the bearing and lip of the oil seal.
: Grease 99000–25010 (suzuki
super
grease “a” or equivalent)
: Moly paste 99000–25140 (suzuki moly paste or equivalent)
Tightening torque starter motor housing bolt (a): 5 n·m (0.5 Kgf-m, 3.5 Lbf-ft)
Radiator / cooling fan motor removal and
installation
Removal
Remove the inner under cowlings. Refer to “exterior parts removal and
installation” in section 9d .
Drain engine coolant. Refer to “cooling system inspection” in section
0b .
Disconnect the reservoir tank inlet hose (1) and
water air bleed hose (2).
Remove ...
Fuel tank cap
To open the fuel tank cap, insert
the ignition key into the lock and
turn it clockwise. With the key
inserted, lift up with the key and
open the fuel tank cap. To close
the fuel tank cap, push the cap
down firmly with the key in the cap
lock.
Fuel level
Fi ller neck
Wa ...
Tire pressure and loading
Proper tire pressure and proper
tire loading are important factors.
Overloading your tires can lead to
tire failure and loss of vehicle control.
Check tire pressure each day
before you ride, and be sure the
pressure is correct for the vehicle
load according to the table below.
Tire pre ...