Suzuki GSX-R 1000 Service Manual: Starter motor removal and installation
Removal
- Turn the ignition switch off and disconnect the battery (–) lead wire (1).
- Lift and support the fuel tank. Refer to “fuel tank removal and installation” in section 1g (page 1g- 9).
- Disconnect the starter motor lead wire (2).
- Remove the starter motor (3).
Installation
Install the starter motor in the reverse order of removal.
Pay attention to the following points:
- apply grease to the o-ring.
: Grease 99000–25010 (suzuki
super
grease “a” or equivalent)
| Caution replace the o-ring with a new one. |
Install the starter motor. Refer to “wiring harness routing diagram” in section 9a .
Starter motor components
O-ring
Housing end (inside)
O-ring
Starter motor case
Armature
Housing end (outside)
10
N·m (1.0 Kgf-m, 7.0 Lbf-ft)
4 N·m (0.4
Kgf-m, 3.0 Lbf- ...
Starter motor disassembly and assembly
Refer to “starter motor removal and installation” .
Disassembly
Disassemble the starter motor as shown in the starter motor components
diagram. Refer to “starter motor components” .
Assembly
Rea ...
Other materials:
Precautions
Keep away from fire or spark.
During disassembling, use care to minimize spillage of
gasoline.
Spilled gasoline should be wiped off immediately.
Work in a well-ventilated area.
For e-33 models, drain fuel from the fuel tank before
...
Ckp sensor removal and installation
Removal
Remove the clutch cover. Refer to “clutch removal” in section 5c .
Remove the ckp sensor (1).
Installation
Install the ckp sensor in the reverse order of removal.
Refer to “clutch installation” in section 5c .
Iap sensor inspection
Refer to “dtc “c13” (p0105-h/l): ia ...
Isc valve reset
When removing or replacing the throttle body assembly,
reset the isc valve learned value in the following
procedures:
turn the ignition switch on position.
Set up the sds tools. (Refer to the sds operation
manual for further details.)
Click “active control”.
Click “is ...