Note make sure the fuses are not blown and the battery is fully-charged before diagnosing. |
Troubleshooting
Step |
Action |
Yes |
No |
1 |
Is the click sound heard? |
Go to step 2. | Go to step 3. |
2 | Check if the starter motor runs when its terminal is connected to the battery (+) terminal. (Do not use thin “wire” because a large amount of current flows.) Does the starter motor run? |
|
Faulty starter motor. |
3 | Measure the starter relay voltage at the starter relay terminal
(between y/g (+) and b/y (–)) when the starter button is
pushed. Is the voltage ok? |
Go to step 4. |
|
4 | Check the starter relay. Refer to “starter relay inspection” . Is the starter relay ok? |
Poor contact of the starter relay. | Faulty starter relay. |
Tightening torque list
Engine
Fi system + intake air system
Cooling system
Chassis
Tightening torque chart
For other bolts and nuts not listed in the preceding page, refer to this
chart:
Conventional bolt
“4” Marked bolt
“7” Marked bolt
...
Fuel tank construction
Fuel tank heat
shield
: aluminum film side should face the engine side.
Fuel tank front cover
Fuel tank front bracket
Velcro fastenings
: clean the adhesive surface before adhering
the velcro fastenings.
Insert
to the bracket.
Apply
...
Swingarm related parts inspection
Refer to “swingarm removal and installation” (page 2c-
9).
Spacers
Remove the collar and spacer from the swingarm.
Inspect the collars and spacer for wear and damage.
If any defects are found, replace them with new
ones.
Chain buffer
Inspect the chain buffer for wear and ...