Inspect the starter relay in the following procedures:
Caution do not apply battery voltage to the starter relay for five seconds and more, since the relay coil may overheat and get damaged. |
Special tool
(a): 09900–25008 (multi circuit
tester set)
Tester knob indication continuity test ( )
Special tool
(a): 09900–25008 (multi circuit
tester set)
Starter relay resistance 3 – 6 Ω
DTC “c11” (p0340): cmp sensor circuit
malfunction
Detected condition and possible cause
Detected condition
Possible cause
The signal does not reach ecm for 3 sec. Or more, after
receiving the starter signal.
Cmp sensor circuit open or short.
Cmp sensor malfunction.
Ecm malfunction.
...
Pair system inspection
Inspect pair system
every 12 000 km (7 500 miles, 24 months)
Inspect the pair (air supply) system periodically. Refer to “pair system
inspection” in section 1b .
Throttle valve synchronization
Inspect throttle valve synchronization
initially at 1 000 km (600 miles, 2 months) (e-33 only)
and ...
Steering damper maintenance
Keep the steering damper
shaft 1 clean at all times.
Wipe off any oil residue with a
cloth.
Do not confuse the grease-like
residue on the steering damper's
shaft with an oil leak. Collection of
this residue is normal and is from
oil seal lubricant used in the
damper.
Yo ...