Removal
Caution make sure that the pawls of the special tool are inserted into the holes of the starter clutch. |
Special tool
(a): 09930–40113 (flywheel rotor
holder)
Installation
Installation is in the reverse order of removal. Pay attention to the following points:
Special tool
(a): 09930–40113 (flywheel rotor
holder)
Tightening torque starter clutch bolt: 54 n·m (5.4 Kgf-m, 39.0 Lbf-ft)
M/o: molybdenum oil (molybdenum oil solution)
Water hose inspection
Inspect the water hoses in the following procedures:
remove the side cowlings. Refer to “exterior parts
removal and installation” in section 9d (page 9d-
6).
Check the water hoses for crack, damage or engine
coolant leakage. If any defect is found, replace the
water hose wi ...
Rear brake pad inspection
The extent of brake pads wear can be checked by observing the grooved limit
line “a” on the pads. When the wear exceeds the grooved limit line, replace the
pads with new ones. Refer to “rear brake pad replacement” .
Caution
replace the brake pad as a set, otherwise
braking performa ...
Starter clutch inspection
Refer to “starter clutch removal and installation” .
Starter clutch
Install the starter driven gear onto the starter clutch.
Turn the starter driven gear by hand to inspect the
starter clutch for a smooth movement. The gear
turns in one direction only. If a large resistance is felt
...