Suzuki GSX-R 1000 Service Manual: Starter torque limiter removal and installation
Removal
- Remove the clutch assembly. Refer to “clutch removal” in section 5c .
- Remove the washer (1), starter idle gear no. 1 (2) And starter torque limiter (3).
Installation
Installation is in the reverse order of removal. Pay attention to the following point:
- apply molybdenum oil solution to the starter torque limiter shaft hole.
M/o: molybdenum oil (molybdenum oil solution)
- Install the clutch assembly. Refer to “clutch installation” in section 5c .
Side-stand / ignition interlock system parts
inspection
Check the interlock system for proper operation. If the
interlock system does not operate properly, check each
component for damage or abnormalities. If any
abnormality is found, replace the compon ...
Starter torque limiter inspection
Removal
Remove the clutch cover. Refer to “clutch removal” in section 5c .
Remove the washers (1), starter idle gear no. 1 (2)
And no. 2 (3).
Remove the starter idle gear no. 2 ...
Other materials:
Tire pressure and loading
Proper tire pressure and proper
tire loading are important factors.
Overloading your tires can lead to
tire failure and loss of vehicle control.
Check tire pressure each day
before you ride, and be sure the
pressure is correct for the vehicle
load according to the table below.
Tire pre ...
Swingarm pivot boss removal and installation
Removal
Remove the swingarm. Refer to “swingarm removal and installation” .
Remove the swingarm pivot boss nut (1).
Note
remove the swingarm pivot boss only when
replacing it.
Remove the swingarm pivot boss (2) by removing its
set screws.
Installatio ...
Specifications
Service data
Electrical
unit: mm
Caution
never use anything except the specified battery.
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Regulator / rectifier construction”
Reference: for the tig ...