Warning
Always ride within the limits of your skills, your motorcycle, and the riding conditions. |
Warning
Always keep both hands on the handlebars and both feet on the footrests of your motorcycle during operation. |
Warning
Reduce your speed and be alert to side winds. |
Make sure that the side stand is in the fully up position. Squeeze the clutch lever and pause momentarily.
Engage first gear by depressing the gearshift lever downward. Turn the throttle grip toward you and at the same time release the clutch lever gently and smoothly. As the clutch engages, the motorcycle will start moving forward. To shift to the next higher gear, accelerate gently, then close the throttle and squeeze the clutch lever simultaneously. Lift the gear shift lever upward to select the next gear and release the clutch lever as you open the throttle again. Select the gears in this manner until top gear is reached.
Note
: this motorcycle has a side stand/ignition interlock switch. If you shift the transmission into gear when the side stand is down, the engine will stop running.
Steering damper maintenance
Keep the steering damper
shaft 1 clean at all times.
Wipe off any oil residue with a
cloth.
Do not confuse the grease-like
residue on the steering damper's
shaft with an oil leak. Collection of
this residue is normal and is from
oil seal lubricant used in the
damper.
Yo ...
Rear wheel dust seal / bearing removal and installation
Removal
Remove the rear wheel assembly. Refer to “rear wheel assembly removal
and installation” .
Remove the rear sprocket mounting drum assembly
(1) from the rear wheel.
Remove the wheel dampers (2).
Remove the dust seal.
Special tool
(a): 09913–50121 (oil s ...
Schematic and routing diagram
Fuel tank drain hose and breather hose routing diagram
Fuel tank water drain hose
Fuel tank breather hose no. 1
Fuel tank breather hose no. 2
Fuel tank breather hose no. 3
3-Way joint
Frame
White marking
Set the
hose end to the root of tank nippl ...