Before attempting to start the engine, make sure:
Note
: this motorcycle has a starter interlock system for the ignition and starter circuit. The engine can only be started if:
When the engine is cold:
When the cold engine is hard to start:
When the engine is warm:
Close the throttle completely and push the electric starter button.
When the warm engine is hard to start:
Warning
Exhaust gas contains carbon monoxide, a gas that is colorless and odorless and can cause death or severe injury. Only run the engine outdoors where there is fresh air. |
Caution Running the engine too long without riding may cause the engine to overheat. Overheating can result in damage to internal engine components and discoloration of exhaust pipes. Shut the engine off if you cannot begin your ride promptly. |
Specifications
Service data
Brake
unit: mm (in)
Tightening torque specifications
Note
the specified tightening torque is described in the following.
“Rear brake components”
Reference: for the tightening torque of fastener not specified in this
section, refer to “tightening torqu ...
Cylinder head disassembly and assembly
Refer to “engine top side disassembly” .
Refer to “engine top side assembly” .
Caution
identify the position of each removed part.
Organize the parts in their respective groups
(i.E., Intake, exhaust, no. 1 Or no. 2) So that
they can be installed in their original
locations ...
Rear brake pedal adjustment
The rear brake pedal position
must be properly adjusted at all
times or the disk brake pads will
bear against the disk causing
damage to the pads and to the
disk surface. Adjust the brake
pedal posit~ on in the following
manner:
Loosen lock nut 1, and turn
the push rod 2 to locate t ...