Do not confuse the grease-like residue on the steering damper's shaft with an oil leak. Collection of this residue is normal and is from oil seal lubricant used in the damper.
You may also notice a sound as the damper shaft is stroked in and out. This "escaping air" type sound is normal and is made as the internal valving damps the shaft movement.
Speed sensor removal and installation
Removal
Remove the left side cowling. Refer to “exterior parts removal and
installation” in section 9d .
Disconnect the speed sensor lead wire coupler (1).
Remove the speed sensor (2).
Installation
Install the speed sensor in the reverse order of removal.
Pay atte ...
Rear brake master cylinder components
Reservoir cap
Plate
Diaphragm
Reservoir tank
Reservoir hose
Brake hose
Brake hose union bolt
Brake hose connector
Master cylinder
Spring
Piston/cup set
Push rod
Dust boot
23 N·m (2.3 Kgf-m,
16.5 Lbf-ft)
10 N·m
...
Break-in procedures
During manufacture only the best possible materials are
used and all machined parts are finished to a very high
standard but it is still necessary to allow the moving parts
to “break-in” before subjecting the engine to maximum
stresses. The future performance and reliability of the
engine depen ...