Engine components removable with the
engine in place
Engine components which can be removed while the engine is installed on the
frame are as follows. For the installing
and removing procedures, refer to respective paragraphs describing each
component.
Center of engine
Item
Removal
Inspection
Installation
...
Piston and piston ring inspection
Refer to “piston ring removal and installation” .
Piston diameter
Measure the piston diameter using the micrometer at 15
mm (0.6 In) “a” from the skirt end. If the piston diameter
is less than the service limit, replace the piston.
Special tool
(a): 09900–20203 (micrometer (50 –
75 mm))
Pis ...
Exhaust pipe bolt and muffler bolt inspection
Tighten exhaust pipe bolts and muffler bolts
initially at 1 000 km (600 miles, 2 months) and every
12 000 km (7 500 miles, 24 months) thereafter
Check the exhaust pipe bolts and muffler bolts to the
specified torque.
Tightening torque
exhaust pipe bolt (a): 23 n·m (2.3 Kgf-m, 16.5 Lbf-ft)
muf ...