Refer to “steering / steering damper removal and installation” .
Inspect the removed parts for the following abnormalities:
Steering stem
Bearing
Steering damper
Note the steering damper operation can be checked without removing it. Refer to “dtc “c93” (p1769): steering damper solenoid valve circuit malfunction” in section 1a . |
Steering system inspection
Refer to “steering system inspection” in section 0b .
DTC “c62” (p0443): evap system purge
control solenoid valve circuit malfunction
(e-33 only)
Detected condition and possible cause
Detected condition
Possible cause
Evap system purge control valve voltage is not input to
ecm.
Evap system purge control valve circuit open or short.
Evap system purge control valve malfunction.
Ecm malfunction. ...
Rod guide case tightening torque
Tighten the rod guide case in the following procedures:
measure the effective length l of the torque wrench.
Calculate the reading torque on the torque wrench by
use of the formula shown below.
Special tool
(a): 09940–84710 (rod guide case
wrench)
T: reading torque on the torq ...
Self-diagnostic procedures
Use of mode select switch
Note
do not disconnect the coupler from ecm,
battery cable from battery, ecm ground
wire from engine or main fuse before
confirming dtc (diagnostic trouble code)
stored in memory. Such disconnection
may erase memorized information in ec ...