Adjust the stp sensor in the following procedures:
Special tool
(a): 09900–25008 (multi circuit
tester set)
(b): 09900–25009 (needle-point probe
set)
Tester knob indication voltage ( )
Stp sensor output voltage st valve is fully closed: approx. 0.7 V ((+): y/w – (–): b/br)
Special tool
: 09930–11950 (torx wrench (5 mm))
Tightening torque stp sensor mounting screw: 3.5 N·m (0.35 Kgfm, 2.5 Lbf-ft)
Regulator / rectifier inspection
Inspect the regulator/rectifier in the following procedures:
turn the ignition switch off.
Disconnect the regulator/rectifier couplers. Refer to “regulator /
rectifier removal and installation” .
Measure the voltage between the terminals using the multi-circuit
tester ...
Starter motor components
O-ring
Housing end (inside)
O-ring
Starter motor case
Armature
Housing end (outside)
10
N·m (1.0 Kgf-m, 7.0 Lbf-ft)
4 N·m (0.4
Kgf-m, 3.0 Lbf-ft)
5 N·m (0.5
Kgf-m, 3.5 Lbf-ft)
Apply grease to sliding
surface
Apply moly ...
Turn signal switch inspection
Inspect the turn signal switch in the following
procedures:
remove the air cleaner box. Refer to “air cleaner box removal and
installation” in section 1d .
Disconnect the left handlebar switch coupler (1).
(Yellow)
Inspect the turn signal switch for continuity wit ...