Removal
Special tool
: 09930–11950 (torx wrench (5 mm))
Note prior to disassembly, mark the stp sensor’s original position with a paint or scribe for accurate reinstallation. |
Installation
Install the stp sensor in the reverse order of removal.
Refer to “throttle body disassembly and assembly” in section 1d .
Stv actuator inspection
Refer to “dtc “c28” (p1655): secondary throttle valve actuator (stva) malfunction” in section 1a (page 1a- 75).
Side standngnition interlock switch
Check the side stand/ignition
interlock system for proper operation
as follows:
Sit on the motorcycle in the
normal riding position, with the
side stand up.
Shift into first gear, hold the
clutch in, and start the engine.
While continuing to hold the
clutch in ...
Accessory use
The addition of unsuitable accessories
can lead to unsafe operating
conditions. It is not possible
for suzuki to test each accessory
on the market or combinations of
all the available accessories; however,
your dealer can assist you in
selecting quality accessories and
installing them correc ...
General description
Combination meter system description
This combination meter mainly consists of a stepping motor, lcd (liquid
crystal display) and leds (light emitting
diode).
The tachometer pointer is driven by the stepping motor.
The lcds indicate followings:
speed, odo / trip 1 / trip 2 / fuel reserve ...