Suzuki GSX-R 1000 Service Manual: Stv actuator removal and installation

Suzuki GSX-R 1000 Service Manual / Engine / Engine electrical devices / Repair instructions / Stv actuator removal and installation

Refer to “throttle body disassembly and assembly” in section 1d .

Caution

never remove the stva from the throttle body.

Isc valve inspection

Refer to “dtc “c40” (p0505 / p0506 / p0507): isc valve circuit malfunction” in section 1a .

Isc valve removal and installation

Refer to “throttle body disassembly and assembly” in section 1d .

Caution

be careful not to disconnect the isc valve coupler at least 5 seconds after ignition switch is turned to off. If the ecm coupler or isc valve coupler is disconnected within 5 seconds after ignition switch is turned to off, there is a possibility of an unusual valve position being written in ecm and causing an error of isc valve operation.
When the throttle body assembly is replaced with a new one, the isc valve must be set present position. Refer to “isc valve preset and opening initialization” .

Stp sensor removal and installation

Removal Remove the throttle body. Refer to “throttle body removal and installation” in section 1d (page 1d- 10). Remove the stp sensor (1) with the special tool. Special tool : 099 ...

Isc valve preset and opening initialization

When removing or replacing the isc valve, set the isc valve to the following procedures: turn the ignition switch on. Set up the sds tool. (Refer to the sds operation manual for f ...

Other materials:

Front brake master cylinder assembly removal and installation
Removal Drain brake fluid. Refer to “brake fluid replacement” . Disconnect the front brake light switch coupler (1). Place a rag underneath the brake hose union bolt (2) on the master cylinder to catch any spilt brake fluid. Remove the brake hose union bolt (2). ...

Water pump related parts inspection
Refer to “water pump disassembly and assembly” . Mechanical seal Visually inspect the mechanical seal for damage, with particular attention given to the sealing face. Replace the mechanical seal that shows indications of leakage. Oil seal Visually inspect the oil seal for damage, with p ...

Specifications
Service data Electrical unit: mm Caution never use anything except the specified battery. Tightening torque specifications Note the specified tightening torque is described in the following. “Regulator / rectifier construction” Reference: for the tig ...